Gullco KBM-28 User Manual download pdf (Page 36)

STORAGE

The KBM

-28 Portable Plate Edge Bevelling Machine should be kept in a dry environment with no

possibility of impact or damage due to stacking of objects on top of the equipment.

It is also recommended that due to the susceptibility of the Clamp Roller Hand Wheel and Revolving

Handle to damage, the Clamp Roller Assembly should be removed for storage.

The machine should be stored with a cutter in place to avoid losing the Cutter Shaft Collar.

When the equipment is brought out of storage, always inspect the condition of the machine prior to

use. Pay particular attention to the condition of the oil.

For storage periods of over 60 days, all machined surfaces should be protected with a suitable anti-

oxidation product.

For storage periods of over 6 months, it is recommended that in addition to the points above, the

gearbox should be filled with extra oil (requiring draining to the correct amount before re-use). It is

also recommended that the rotor be turned every 1 to 2 months and to take adequate measures

against corrosion and humidity.

SHIPPING

When shipping the KBM

-28 bevelling machine without the optional undercarriage, lag bolt the

tilting frame to the skid. If the unit is being shipped with the undercarriage, it is recommended that

the machine be secured to a skid that raises the four (4) casters off the floor.

The Clamp Roller Assembly should be removed from the Cutter Shaft Housing to protect it from

damage.

The machine should be shipped with a cutter in place to avoid losing the Cutter Shaft Collar.

The starter switch assembly should either be removed or protected against damage.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 57 58

No comments

Gullco KBM-28 User Manual Page 36