Gullco KBM-28 User Manual download pdf (Page 15)

OPERATION

BEVEL SETTINGS

1. Positively isolate/disconnect the

AC power supply.

2. Clean the area around the Main

Roller and Slide Base Assembly,

then loosen the Slide Base

Clamping Bolt.

3. Lower the Slide Base Assembly by

turning the Slide Base Adjusting

Bolt counter-clockwise.

4. Loosen the nut of the Angle

Alignment Bolt.

5. Loosen the Wing Screw.

6. Tilt the Pivot Arm Assembly

upward.

7. Unscrew and remove the Angle

Pin.

8. Screw in the correct Angle Pin to match the desired bevel angle to be produced.

Note: Hydraulic

undercarriage may not be

as shown.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 57 58

No comments

Gullco KBM-28 User Manual Page 15